How To Control The Waste Of Gluing With a Glue Gun?

When using a glue gun, there are often cases of glue hitting too much. How to reduce the waste of gluing? Read on for more information.

Recycling of glue

Each project has its own characteristics. After the surface glue on the board is beaten, the glue is scraped and replenished. It is observed that the actual utilization rate of each glue is less than 60%, and the remaining glue is scrapped in a big pile. The remaining glue can be recycled: according to each project, the use of different ways and methods need to be considered.

Equipment

The manual glue gun is controlled by a person, so there is some control over the amount of glue coming out of the gun. It will also avoid many factors that lead to glue repair. The hand glue gun is more economical compared to the pneumatic glue gun. But the efficiency will be reduced. If the production cycle of the project allows, it is recommended that the surface glue of the board be played by a manual glue gun.

Accessories

Foam sticks, the design gives the theoretical size of foam sticks according to the drawing. However, various errors or other factors lead to the installation of foam rods of unsuitable size, too big, or too small. Workers will be installed according to the drawings, too small size of the foam stick will increase the amount of glue. It is recommended that the design of each project should indicate the size of each seam on the slab and the size of the selected foam rod on the top of the drawing. Also, the project manager of each project should arrange for someone to check the size of the foam rods on each part when assembling the first layer or the first floor. The process should also communicate more with the assembled workers, and their opinions or suggestions will be of great help to the smooth running of the project as a whole.

Gluing workers

A professional gluer will be more proficient in operating the gluing equipment and forming the product at once. There is no need for redundant glue, glue repair, and other steps, from the approach has begun to save. Of course, professional curtain wall workers should be developed in many aspects, diversified training. But it is necessary to cultivate more professional and skilled glue-beaters on this basis. The mobility of factory workers is too great, and whether such workers can be retained is also a constraint.

We are a glue gun supplier, please feel free to contact us if you need them.